In 10 steps to your unique controller
How is your controller actually made? What are the steps behind it? Why is delivery not possible in 2–3 days?
In order to clarify all these questions, we have created a production overview of a controller for you.
Of course, not every controller is the same, but to give you an insight, we cordially invite you to read through our production process.
Step 1
Receipt of your order.
We check your data for correctness and completeness. Have you already paid? Then we create your delivery note and start with your production. First, an original controller is broken down into parts and sorted.
Step 1
Foiling:
Does your upper case have a foil design?
The right water transfer printing foil is selected, your case is prepared
and the foil is applied with water transfer printing. We combine the same designs to save time. Your case must then dry for at least 36 hours so that the film cannot peel off.
Paintwork:
Does your upper case have a paint design?
The right paint is selected, your case is prepared and painted together with many of the same cases. Our painter does not have to laboriously clean the spray gun after each case and can save a lot of time. The drying time is then approx. 12 hours.
Step 3
After the respective drying time, a protective layer of varnish must be applied. We use high-quality soft-touch paint for a pleasant hand feeling.
The drying time of the protective coating is another 12 hours, since it has to harden completely.
Step 4
After the respective drying time, a protective layer of varnish must be applied. We use high-quality soft-touch paint for a pleasant hand feel.
The drying time of the protective coating is another 12 hours, since it has to harden completely.
Step 5
The delivery notes are sorted into the finished cases. The finished cases are inspected and checked for production defects. Is the processing good? Then it's on to the workshop. Are there any irregularities? Then the case has to be processed again.
Step 6
Your delivery note has arrived at the workshop with your cases. The material list according to the delivery note is checked and the correct components are collected.
A final check of your configuration takes place.
Step 7
Missed your controller paddles? Then the correct circuit board is inserted and soldered to the paddles. Your controller is almost ready!
Step 8
The assembly of your controller is complete.
Your controller will now be tested for its functions. At the same time, two employees check whether errors have occurred. Only after quality control is the controller released for delivery.
Step 9
Your invoice will be printed and sorted to your controller. The configuration according to the delivery note is compared with the controller and the shipment is prepared.
Step 10
Your controller will be packed and the shipping label will be created. DHL will announce the shipment and hand it over at the end of the day. Your controller is now on its way to you!